Remove existing anode rod or rods. Drain out 2 quarts of water from water heater. Add 2 pints of 3% hydrogen peroxide (available at drug stores) through anode rod hole. Install an aluminum zinc rod, or Power Anode. Pressurize water heater and let stand 20-30 minutes. Purge all of the hot taps individually until warm water comes out of the tap. Finally flush heater under pressure through drain valve for 5 minutes. To achieve superior results install a curved dip tube and full port ball valve for a turbo flush. (refer to TankSaver Kit installation manual for instructions).


For more information click here